Solar water heaters are a popular choice for many households and looking to reduce their energy consumption and carbon footprint. An installation of a solar water heater is a better option to reduce our electricity bill. Moreover one can be an attractive option, but the process is not without its challenges. And this article will explore the steps involved in setting up a solar water heater installation.
In addition, the location of the system should also be carefully considered and ideally you want maximum exposure to sunlight while avoiding areas where shadows or other obstructions may interfere. Moreover with these factors in mind and let’s take a look at how to install and a solar water heater system from start to finish.
The first step of most solar hot water installations is to put the solar collectors in place on your roof. The installer makes sure of mounting the collectors properly and therefore, he may need to remove portions of your roof shingling and expose the flat tar paper that acts as protection between your shingles and roof deck.
The second step is to fix the storage tank, which is the largest part of a solar hot water system as your collectors need a storage tank where they can send their heated antifreeze transfer fluid. .
Next, your installer will run flexible piping from your roof to your new storage tank or tanks to connect your collectors to the heat exchanger and storage tanks.
As water with antifreeze fluid needs to be cycled through your new solar hot water setup and water transport lines are required to be run from your storage tank to the rest of your home.
Then, the installer needs two temperature sensors to be connected with wiring and installed along with your hot water system; one sensor should be connected to your collectors, and another one to the base of your storage tank.
Error: Contact form not found.
22/700C, Arikat Arcade, Mala Road, Aloor P.O.-680683, Thrissur Dist.
